Shenzhen Handar Optical Technology Co.,Ltd
Shenzhen Handar Optical Technology Co.,Ltd Details determine success or failure, choose the future of success
Add to Cart
Copper 10Gbps SFP Transceiver HD-10GLC-T RJ45 Port SFP Max 20M
Product Features
Applications
1. Product Description
The HD-10GLC-T is Copper Small Form pluggable (SFP) transceiver, which are based on SFP multi-sourcing agreement (MSA). They are compatible with the 10GBASE-T and 1000BASE-T standards as specified in IEEE Std 802.3.The 1000BASE-T physical layer IC(PHY) can be accessed via I2C,allowing access to LIMITED PHY settings and features
2. Regulatory Compliance
Handar transceivers are Class 1 Laser Products comply with FDA regulations. Meet Class 1 eye safety requirements of EN 60825 and the electrical safety requirements of EN 60950.
3. +3.3V Volt Electrical Power Interface
The HD-10GLC-T has an input voltage range of 3.3V +/-5%,The 4 V maximun voltage is not allowed for continuous operation.
| Parameter | Symbol | Min. | Typ | Max | Units | Notes/Conditions |
| Supply Current | Is | 600 | mA | 1.2W max power over full range of voltage and temperature. see caution note below | ||
| Power Supply Voltage | Vcc | 3.13 | 3.3 | 3.47 | v | Referenced to GND |
| Maximum Voltage | Vmax | 4 | v | |||
| Surge Current | Isurge | 550 | mA | Hot plug above steady state current, See caution note below |
Caution: Power consumption and surge current are higher than the specified values in the SFP MSA
Table 1.+3.3 Volt electrical power interface
4. Low-Speed Signals
| Parameter | Symbol | Min. | Max | Units | Notes/Conditions |
| SFP Output LOW | VOL | 0 | 0.5 | V | 4.7k to 10k pull-up to host Vcc, measured at host side of connector |
| SFP Output HIGH | VOH | Host Vcc-0.5 | Host Vcc+0.3 | V | 4.7k to 10k pull-up to host Vcc, measured at host side of connector |
| SFP Input LOW | VIL | 0 | 0.8 | V | 4.7k to 10k pull-up to Vcc, measured at SFP side of connector |
| SFP Input HIGH | VIH | 2 | Vcc+0.3 | V | 4.7k to 10k pull-up to Vcc, measured at SFP side of connector |
Table 2. Low-speed signals, electronic characteristics
5. High-Speed Electrical Interface
ALL high-speed signals are AC-coupled internally
(1)High-speed Electrical Interface Transmission Line-SFP
| Parameter | Symbol | Min. | Typ | Max | Units | Notes/Conditions |
| Line Frequency | fL | 10 | 125 | 1000 | MHZ | 5-level encoding, per IEEE 802.3 |
| Tx Output Impedance | Zout,TX | 100 | Ohm | Differential, for all frequencies between 1MHz and 125MHz | ||
| Rx Input Impedance | Zin,RX | 100 | Ohm | Differential, for all frequencies between 1MHz and 125MHz |
Table 3. High-speed electrical interface, transmission line-SFP
(2)High-speed Electrical Interface, Host-SFP
| Parameter | Symbol | Min. | Typ | Max | Units | Notes/Conditions |
| Single ended data input swing | Vinsing | 180 | 700 | mV | Single ended | |
| Single ended data output swing | Voutsing | 350 | 800 | mV | Single ended | |
| Rise/Fall Time | Tr,Tf | 175 | psec | 20%-80% | ||
|
Tx Input Impedance
|
Zin | 50 | Ohm | Single ended | ||
| Rx Output Impedance | Zout | 50 | Ohm | Single ended |
Table 4. High-speed electrical interface, host-SFP
6. General Specifications
| Parameter | Symbol | Min. | Typ | Max | Units | Notes/Conditions |
| Data Rate | BR | 10 | 10000 | Mb/sec | IEEE 802.3 compatible. See Notes 2 through 4 below | |
| Tx Output Impedance | L | 100 | M | Category 5 UTP.BER<10-12 |
Table 5. General specifications
Note:
1.Clock tolerance is +/- 50 ppm
2.By default, the HD-10GLC-T is a full duplex device in preferred master mode
3.Automatic crossover detection is enabled. External crossover cable is not required
4.Multi-BASE-T operation requires the host system to have an SGMII interface with no clocks, and the module PHY to be configured per Applications Note AN-2036.With a SERDES that does not support SGMII, the module will operate at 1000BASE-T only.
7. Environmental Specifications
The HD-GLC-T1/2 has an extended range from 0℃ to +85℃ case temperature as specified in Table.
| Parameter | Symbol | Min. | Typ | Max | Units | Notes/Conditions |
| Operating Temperature | Top | 0 | 70 | Case temperature | ||
| Storage Temperature | Tsto | 0 | 70 | Ambient temperature |
Table 6. Environmental specifications